Safety Instructions - Behringer NOISE REDUCER NR300 Manual Del Usuario

2 NOISE REDUCER NR300
The 1/4" TS OUT connector sends the signal to your amp.
(8)
Use this 1/4" TS SEND connector to connect it to the input
(9)
of an external effect unit. This way you can feed in an effect
signal while simultaneously eliminating noises from the unit.
The 1/4" TS RETURN connector is used to feed in the external
(10)
effect signal.
Use the DC IN connection to plug in a 9 V power supply (not included).
The BATTERY COMPARTMENT is located underneath the pedal cover.
To install or replace the 9 V battery (not included), press the hinges
with a ballpoint pen and remove the pedal cover. Be careful not to
scratch the unit.
◊ ◊
The NR300 has no on/off switch. As soon as you insert the
jack into the in connector, the NR300 begins running.
When not using the NR300, remove the jack from the in
connector. This extends the life of the battery.
The SERIAL NUMBER is located at the bottom.

2. Safety Instructions

Do not use near water, or install near heat sources. Use only authorized
attachments/accessories. Do not service product yourself. Contact our
qualified servicing personnel for servicing or repairs, especially when
power supply cord or plug is damaged.
3. Limited Warranty
For the applicable warranty terms and conditions and additional
information regarding Music Tribe's Limited Warranty, please see
complete details online at community.musictribe.com/pages/
support#warranty.
4. Specifications
In
Connector
Impedance
Out
Connector
Impedance
Send
Connector
Impedance
Return
Connector
Impedance
1/4" TS
500 kΩ
1/4" TS
1 kΩ
1/4" TS
1 kΩ
1/4" TS
50 kΩ