Resfriar RES67GE Manual Del Propietário página 43

PRoBlEM
The refrigerator does not turn on and the failure
indicator LED does not work.
Dust entering in your refrigerator
The lighting does not work
(RES67GE, RES31GP, RES31GP/4VR)
Condensation of liquids internally
Condensation of liquids externally
PoSSiBlE CauSE
The refrigerator is not connected to the battery
The LED light is burned out
Damaged sealing gaskets or out of the socket
Switch is locked
Cables are unplugged
Defective LED board
Frequency of door or lid opening
Unpacked food and open containers with liquids
Storage of hot food in the refrigerator
Poorly closed lid
Insufficient sealing of gaskets around the lid
High air humidity (normal in certain climates and
seasons)
Poor sealing of the lid gaskets
Solution
Check the electrical connection
Replace the LED light
Replace the damaged sealing gaskets or reposi-
tion them accordingly
Replacement is required
Connect the cables to the power
Replace the LED board
Open the door or lid only when necessary
Pack food and close the containers with liquids
properly
It is preferable to put the food in the refrigerator
at room temperature or even cooler
Make sure that the lid is properly closed prevent-
ing the entry of air
Make sure the sealing gaskets are not damaged
or in the right position
Install the refrigerator in a place with good air
circulation, observing the distances required
Make sure the sealing gaskets are not damaged
or in the right position
43