Salter 9063 WH3R Manual De Instrucciones página 2

HOW DOES THIS SALTER SCALE WORK?
GB
This Salter scale allows effective weight management through Goal Tracking.
This scale stores the personal data of up to 8 users. As well as Goal Tracking this
scale can be used as a conventional scale.
NEW FEATURE!
This scale features our convenient step-on operation. Once initialised the scale can
be operated by simply stepping straight on the platform – no more waiting!
PREPARING YOUR SCALE
1. Open the battery compartment on the scale underside.
2. Insert batteries (4 x AAA) observing the polarity signs (+ and -) inside the battery
compartment.
3. Close the battery compartment.
4. Select kg, st or lb weight mode by the switch on the underside of the scale.
5. For use on carpet remove the non-slip pads from the scales feet and attach
enclosed carpet feet.
6. Position scale on a firm flat surface.
INITIALISING YOUR SCALE
1. Press the platform centre and remove your foot.
2. '0.0' will be displayed.
3. The scale will switch off and is now ready for use.
This initialisation process must be repeated if the scale is moved.
At all other times step straight on the scale.
WEIGHT READING ONLY
1. Step on and stand very still while the scale computes your weight.
2. Your weight is displayed.
3. Step off. Your weight will be displayed for a few seconds.
4. The scale will switch off.
DISPLAY GUIDE
User number
Memory position
SET GOAL WEIGHT
1. Press button. User number will flash. Press s or t as necessary to select
your user number, press to confirm.
2. Goal Weight will flash. Press s or t as necessary to set your goal weight,
press to confirm.
3. Your goal weight is set and then the scale will turn off.
4. Repeat the procedure for a second user, or to change user details.
WEIGHING WITH GOAL TRACKER
1. Press button. User number will flash. Press s or t as necessary to select
your user number.
2. Wait until 0.0 is displayed.
3. Step on and stand very still while the scale computes your weight.
4. Your Weight is displayed for a few seconds followed by Goal Weight and Goal
Weight Difference.
Note: The Goal Weight Difference is shown as follows:
#
A up arrow shows weight above goal weight.
$
A down arrow shows weight below goal weight.
If no Goal Weight is set ---- will be displayed. To set Goal Weight see SET GOAL
WEIGHT section above.
WEIGHT HISTORY RECALL
The scale can store the last 4 results for each user. To view the results history:
1. Press button. User number will flash. Press s or t as necessary to select
your user number.
2. Wait until 0.0 is displayed.
3. Press and hold unit switch for 3 seconds to enter recall mode.
4. M1, Weight and Goal Weight Difference will be displayed.
5. Press s or t to view M1-M4.
Note: If a memory location has no record ---- will be displayed.
RESET MEMORY
1. Follow steps 1-3 above to enter WEIGHT HISTORY RECALL.
2. Press and hold s and t together for 3 seconds to enter reset mode.
3. RE:SET will be displayed.
4. Press s or t as necessary to select YES or NO. Press
5. If YES selected scale shows ---- then will turn off.
6. If NO selected scale turns off.
WARNING INDICATORS
Err Unstable weight. Stand still.
O-Ld Weight exceeds maximum capacity.
Lo Replace battery.
ADVICE FOR USE AND CARE
• Always weigh yourself on the same scale placed on the same floor surface.
Do not compare weight readings from one scale to another as some
differences will exist due to manufacturing tolerances.
• Placing your scale on a hard, even floor will ensure the greatest accuracy and
repeatability.
• Weigh yourself at the same time each day, before meals and without footwear.
First thing in the morning is a good time.
• Your scale rounds up or down to the nearest increment. If you weigh yourself
twice and get two different readings, your weight lies between the two.
• Clean your scale with a damp cloth. Do not use chemical cleaning agents.
• Do not allow your scale to become saturated with water as this can damage
the electronics.
• Treat your scale with care - it is a precision instrument. Do not drop it or jump on it.
TROUBLESHOOTING GUIDE
If you experience any difficulty in the use of your scale:
• Check the battery is correctly fitted.
• Check that you have selected your preference of stones/pounds, kilograms or
pounds.
• Check that the scale is on a flat, level floor and not touching against a wall.
• If when you use the scale there is no display at all or if 'Lo' is displayed - try a
Weight
new battery.
• If 'O-Ld' is displayed the scale has been overloaded.
WEEE EXPLANATION
Goal weight/
Goal weight difference
This marking indicates that this product should not be disposed with other
household wastes throughout the EU. To prevent possible harm to the
environment or human health from uncontrolled waste disposal, recycle it
responsibly to promote the sustainable reuse of material resources. To return your
used device, please use the return and collection systems or contact the retailer
where the product was purchased. They can take this product for environmental
safe recycling.
GUARANTEE
This product is intended for domestic use only. Salter will repair or replace the
product, or any part of this product, (excluding batteries) free of charge if within
15 years of the date of purchase, it can be shown to have failed through defective
workmanship or materials. This guarantee covers working parts that affect the
function of the scale. It does not cover cosmetic deterioration caused by fair wear
and tear or damage caused by accident or misuse. Opening or taking apart the
scale or its components will void the guarantee. Claims under guarantee must be
supported by proof of purchase and be returned carriage paid to Salter (or local
Salter appointed agent if outside the UK). Care should be taken in packing the
scale so that it is not damaged while in transit. This undertaking is in addition to a
consumer's statutory rights and does not affect those rights in any way.
For UK Sales and Service contact HoMedics Group Ltd, PO Box 460, Tonbridge, Kent,
TN9 9EW, UK. Helpline Tel No: (01732) 360783. Outside the UK contact your local
Salter appointed agent.
2
to confirm.