TECshow STRATUS FAZER Manual De Usuario página 4

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

water.
Never lock smoke-filled rooms. Risk: panic
among the locked persons!
Never smoke permanently! The smoke must
only be used for a short period -
Do not insert objects into air vents.
Do not open the device and do not modify the
device.
Do not connect this device to a dimmer pack.
Do not switch the device on and off in short
intervals, as this would reduce the device's life.
Do not touch the fazer output bare-handed dur-
ing its operation (output becomes very hot).
Do not shake the device. Avoid brute force
when installing or operating the device.
Only use device indoor, avoid contact with wa-
ter or other liquids.
Only use smoke in well ventilated rooms.
Only use the high-quality, water-based fog liq-
uid, that your Showtec dealer recommends (5L
fazer fluid ordercode 60603). Other fog liquids
may cause poor effect fog, clogging and "spit-
ting" of unevaporated liquid.
Avoid flames and do not put close to flammable
liquids or gases.
Always make sure there is sufficient liquid in
the fog liquid tank. Operating this unit without
liquid will cause damage to the pump and the
heater.
Always allow free air space of at least 20cm
around the sides and top of the unit.
Always drain tank before shipping or otherwise
transporting this unit.
Always keep tank cap closed while operating.
Always keep the fog machine upright.
Always unplug your Fog Machine before filling
its tank.
For adult use only. Fog machine must be in-
stalled out of the reach of children. Never leave
the unit running unattended. Leave the grid
guarding the nozzle in place if the machine is to
be used in the presence of children
Always keep the nozzle at least 50cm away from
contact with anything, while in operation.
P. 4
Tecshow Stratus Fazer | English version
Always disconnect power from the mains, when
device is not used or before cleaning! Only han-
dle the power-cord by the plug. Never pull out
the plug by tugging the power-cord.
Make sure that the available voltage is not high-
er than stated on the rear panel.
Make sure that the power-cord is never crimped
or damaged. Check the device and the power-
cord from time to time.
Make sure that the core diameter of extension
cords and power cords is sufficient for the re-
quired power consumption of the device.
The cable insert or the female part in the device
must never be strained. There must always
be sufficient cable to the device. Otherwise,
the cable may be damaged which may lead to
deadly electrical shocks.
If the external cable is damaged, it has to be
replaced by a qualified technician.
If device is dropped or struck, disconnect mains
power supply immediately. Have a qualified
engineer inspect for safety before operating.
If the device has been exposed to drastic tem-
perature fluctuation (e.g. after transportation),
do not switch it on immediately. The arising
condensation water might damage your de-
vice. Leave the device switched off until it has
reached room temperature.
If your Fog Machine fails to work properly, dis-
continue use immediately. Drain all fog liquid
from the tank, pack the unit securely (prefera-
bly in the original packing material), and return
it to your Showtec dealer for service.
For replacement use fuses of same type and
rating only.
Allow time to cool down, before cleaning or
servicing.
The residence time of persons in smoke-filled
rooms with less than 15m of sight must never
exceed 5 minutes.
The fog vapour at point of release is under pres-
sure and is extremely hot.
The output nozzle becomes very hot during
operation (300 degrees C). Keep flammable ma-

Publicidad

Tabla de contenido
loading

Tabla de contenido