Osd Menu Confi Gurations; No Signal Display; Osd Menu Selection; Video Mode - Sanyo VMC-L2017 Manual De Instrucciones

OSD Menu Configurations

No Signal Display

When there is no connection to the VGA and Video
input, the On Screen Display will show this message.
No Signal
<Video mode>
Check signal cable.
<VGA mode>

OSD Menu Selection

1. Press the MENU button to see the main menu.
2. Press / and ENTER button to select the main
menu.
3. Press / and ENTER (or
sub menu.
4. Press / and ENTER (or
setting. (Or press /
5. Press the MENU or
NOTE1: Press the MENU or
the previous screen.
NOTE2: The OSD display will be disappear after 2
minutes if there is no button input.
7 English
VGA
) button to select the
) button to select
button to select setting)
button repeatedly to exit.
button to return to

Video mode

Input Menu

Source List
P7
PIP
Edit Name
P8
P9
P10
Move
Source List
Video A
Video B
S-Video
VGA
Move
1. Press the MENU and ENTER button.
2. Press the ENTER or
button to select the Video A, Video B or S-Video.
3. Press the ENTER or
and exit.
PIP
"PIP" is available in VGA mode.
See " PIP (Picture In Picture)" on page 11.
Edit Name
Video A
Video B
S-Video
VGA
Move
- - - -
CAMERA
DVR
VCR
DVD
Cable STB
AV Receiver
DVD Receiver
Move
1. Press the MENU and ENTER button.
2. Press the / and ENTER button to select the
Edit Name menu.
3. Press the / and ENTER button to select input.
4. Press the / and ENTER button to select the name.
5. Press the MENU or
Input
: Video A
Enter Exit
Source List
: - - - -
: - - - -
: - - - -
: - - - -
Enter Return
button and then /
button to save the setting
Edit Name
: Cable STB
: - - - -
: DVD Receive
: VGA
Enter Return
Edit Name
Enter Return
button repeatedly to exit.