Publicidad
Idiomas disponibles
Idiomas disponibles
REPEAT STEPS 1 THROUGH 7 FOR PASSENGER SIDE OF VEHICLE USING LAMP (A).
Répétez les étapes 1 à 7 pour le côté passager du véhicule en utilisant la lampe de brouillard (A)
Repita los pasos 1 a 7 para el lado del pasajero del vehículo con luz antiniebla (A)
8
VEHICLE PREPARATION FOR LAMP ALIGNMENT - DOMESTIC MARKET ONLY
1. Check for and correct any burnt out bulbs.
2. Repair or replace any ineffective, worn or damaged body or suspension components that could hinder proper lamp alignment.
3. Verify proper tire inflation pressures.
4. Remove any accumulations of mud, snow or ice from the vehicle underbody and clean the front lamp lenses.
5. Verify that there is no load in the vehicle (cargo or passengers), except for the driver.
6. The fuel tank should be FULL. Add 2.94 kilograms (6.5 pounds) of weight over the fuel tank for each estimated gallon of
missing fuel.
7. Verify correct vehicle suspension height.
FOG LAMP ALIGNMENT
NOTE: A properly aimed front fog lamp will project a
pattern (top of fog light pattern) on the alignment screen
100 millimeters (4 inches) below the fog lamp centerline
and straight ahead of the lamp.
1. Turn the fog lamps ON.
2. Insert a screwdriver through the clearance hole in the
underside of the front bumper (1) to rotate the vertical
adjustment screw (2) on each fog lamp to adjust the
beam height as required
8-18-15
www.mopar.com
3
K6862254
Publicidad
