Technical Data; First Use And Charging The Batteries - therm-ic PowerGloves Modo De Empleo

Charger
 Mains power supply with country-specific adapter
(2.1) - back
 Charge indicator (2.2)
 Charging cable with plug (2.3)
TECHNI CA L DATA
Charger (accessory available from Therm-ic)
 Input: 100 – 240V (50-60Hz)
 Output: 2 x 4.2 V / 0.5 A
Lithium-ion dual batteries (accessory available from
Therm-ic)
 3.7 V / 2600 mAh
FI RST US E AND CHARGI NG THE
B A T T E RIE S
The batteries must be charged before using them
for the first time.
11
1. Plug the charger into a socket; the charge
indicator (2.2) will light up in green. Afterwards
plug both batteries into the charger. The load
process will start automatically and the charge
indicator (2.2) will light up in red during charging.
2. The charging time is approximately 6 to 7 hours.
3. Once the batteries have been fully charged, the
charging process is automatically concluded and
the LED on the charge indicator (2.2) will go
back to green.
4. Remove both batteries from the charger.
5. Connect the batteries back with the glove
(engage connectors).
Important note:
 Recharge the batteries after each use. This will
protect the batteries and ensure your Therm-ic
PowerGloves are always ready.
 The battery consists of lithium ion cells and can
be charged in any state. It is therefore
unnecessary to fully discharge the battery before
charging.