Inserting / Replacing The Batteries; Use And Functions - therm-ic PowerGloves Modo De Empleo

I NSTRUCTI ONS FOR USE / ENGLI SH
The battery consists of lithium ion cells and can be
charged in any state. It is therefore unnecessary to
fully discharge the battery before charging.
I NSE RTI NG / RE P LA CI NG THE
B A T T E RIE S
If the batteries in your PowerGlove become no
longer fully-functional (reduced heating times;
battery fails to recharge), you will need to replace
them.
To replace the batteries, proceed as follows:
1. Open the side pockets on the glove (1.5).
2. Disconnect the battery cable (1.3) from the glove
(1.4).
3. Remove the batteries and replace them with
new ones. Dispose of the old batteries properly.
4. Connect the battery cable to the glove and close
the side pockets.
Caution!
Never try to open a battery pack yourself! Improper
handling of the Li-Ion batteries can lead to an
explosion! The electronics of the PowerGloves can
also be damaged!
U S E A N D F U N CT I O NS
Therm-ic PowerGloves have four operating modes:
POWER-OFF – LEVEL 1, 2 and 3. These are clear
to see on the heat level indicator display (1.1) – the
number of LED's corresponds to the selected level.
The Therm-ic PowerGlove has a control pad with
two control buttons (1.2) to set the heat level.
These can be used to choose between 3 different
heat levels. The Therm-ic PowerGloves are
switched off when none of the LEDs on the heat
level indicator is lit up.
Turning on: Briefly press the control button "+"
or "-" (approx. 1 sec.) to turn the
Therm-ic PowerGlove on at the
lowest heat level.
12