V-TAC VT-5129 Manual Del Usuario página 6

IF THE RECEIVER IS IN OPEN STATE,
- Turn on the tradi�onal switch to light the lamps, the wireless switch can control the lamps.
- Turn off the tradi�onal switch to light the lamps, the wireless switch cannot control the lamps.
METHOD OF SETTING THE RECEIVER IN OPEN STATE
Press and hold switch bu�on for 16s, loosen your finger when the indicator light is con�nuously
bright. (During the 16s, the indicator light will change from quick flash to slower flash, a�er
that, the indicator light will be off, then will be on.)
METHOD OF SETTING THE RECEIVER IN CLOSE STATE
Press and hold switch bu�on for 16s, loosen your finger when the indicator light is con�nuously
bright.
REPLACE THE BATTERY
1. Remove switch frame and panel with hand or screwdriver.
2. Remove 4 screws with screwdriver, take off the ba�ery cover
3. Replace the old ba�ery with the new one, pay a�en�on to the posi�ve and nega�ve poles
of the ba�ery;
4. Install the panel and frame again.
WIRELESS SWITCH INSTALLATION
The switch can be surface mounted with screws or double-sided s�ckers or set it on the table.
1.Install with Double-sided adhesive. (Included)
FIGURE 12
FIGURE 13
ENGLISH