Electrical Connection; Technical Data - Hotpoint Ariston LF 70 Manual De Instrucciones

Ocultar thumbs Ver también para LF 70:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Connecting the water outlet hose
Connect the outlet hose (without bending it) to a
drain duct with a minimum diameter of 4 cm.
Alternatively, rest it over a sink or tub; the free end
of the hose should not remain immersed in water.
A
100 cm above the ground ( see figure ).
We advise against the use of hose extensions.

Electrical connection

Before inserting the plug into the electrical socket,
make sure that:
• the socket is earthed and complies with current
regulations;
• the socket can withstand the maximum load of
the appliance, which is indicated on the data
plate located on the inside of the door ( see
Description of the appliance );
• the power supply voltage falls within the values
indicated on the data plate on the inside of the
door;
• the socket is compatible with the plug of the
appliance. If this is not the case, ask an
authorised technician to replace the plug ( see
Assistance ); do not use extension cables or
multiple sockets.
Once the appliance has been installed, the
power supply cable and the electrical socket should
be easily accessible.
The cable should not be bent or compressed.
If the power supply cable is damaged, it must
be replaced by the manufacturer or its Technical
Assistance Service in order to prevent all potential
hazards. (See Assistance)
The Company shall not be held responsible for
any incidents that occur if these regulations are not
observed.
The special plastic elbow*
makes it easier to find the
best layout: fix the elbow
to the wall securely in
order to prevent the outlet
hose from moving and
spilling the dirty water.
The part of the hose
marked with the letter A
should be between 40 and
Advice regarding the first wash cycle
After the appliance has been installed, immediately
before running the first wash cycle, completely fill
the salt dispenser with water and add approximately
2 kg of salt ( see Rinse aid and refined salt ). The
water may overflow: this is normal and is not a
cause for concern. It is also normal that the LOW
SALT* indicator light continues to flash for a few
cycles after the salt has been loaded.

Technical Data

width 60 cm
Dimensions
height 85 cm
depth 60 cm
Capacity
12 standard place-settings
Water supply
0,05 ÷ 1MPa (0.5 ÷ 10 bar)
pressure
4.3 psi – 145 psi
Power supply
See appliance data plate
voltage
Total absorbed
See appliance data plate
power
Fuse
See appliance data plate
This dishwasher conforms to
the following European
Community Directives:
-73/23/EEC dated 19/02/73
(Low Voltage) and subsequent
modifications
-89/336/EEC dated 03/05/89
(Electromagnetic Compatibility)
and subsequent modifications
-97/17/EC (Labelling)
-2002/96/ CE Waste Electrical
and Electronic Equipment
(WEEE)
* Only available in selected models.
EN
15

Publicidad

Capítulos

Tabla de contenido
loading

Este manual también es adecuado para:

Lf 69

Tabla de contenido