acenta_final.qxd
22/2/05
HANDLE ASSEMBLY (1)
The handle must be assembled to the
cleaner before use, unless being used
with the shoulder strap - see (6).
1. Remove hand-screw from handle.
2. Slide handle over top of cleaner.
3. Tighten hand-screw.
CORD STORAGE (2)
a) Wind cord around hooks.
Secure cord with integrated clip.
b) Undo integrated clip.
Turn both hooks inwards as shown
to release cord.
ACCESSORIES (3)*
a) Shoulder strap *
b) Flexible hose *
c) Extension tube
d) Furniture nozzle
e) Crevice tool
f) Dusting brush *
NOZZLES (3)*
g) Carpet & Floor nozzle: press pedal to
bring brushes in contact with hard
floor.
h) Delicate Floor nozzle*: for wooden
floors and all delicate floors.
i) Turbonozzle*: especially for carpets.
l) Electric Power nozzle*: for deep
cleaning of large areas of carpet.
12:27 PM
Page 8
CONTROLS (4)*
a) ON / OFF switch
b) Power control*
POWER NOZZLE (5)*
When using Electric Power nozzle*
insert nozzle electric plug into socket on
back of cleaner (behind control panel).
SHOULDER STRAP
a) With nozzle removed, slide one end
b) With main handle removed - see (1)
c) Carry the cleaner over the shoulder
* Feature varies according to model
Push to switch on.
Push again to switch off.
Slide to the right to increase.
Slide to the left to decrease.
of shoulder strap over tube at base
of cleaner. Slide the strap end past
the locking tab and rotate as shown.
Refit with accessories depending on
use.
clip other end of the shoulder strap
to top of stub handle.
as shown.
(6)*