Kettler CellaCast PX 8x Manual De Instrucciones página 21

Quick Start Guide CellaCast PX 8x
The IODDs required for configuring the IO-Link device as well as detailed information on process data
setup, diagnostic functions and parameter addresses are available in the download area at
www.keller.de/its.
ATTENTION
For IO-Link operation, a 3-wire shielded cable port Class A (Type A) must
be used.
12 Trouble Shooting
No measured values are determined.
The measuring system CellaCast checks the validity of the measured values at each measure-
ment and calculates the signal strength. The value for the signal strength must be > 5 %. The
signal strength is only indicated during the casting process.
Parameter
Q . S i6
Checking the signal intensity
► Press [Mode]
> The display shows [Ao]
► Press the key [▼] until the parameter [Qu] is shown in the display
► Press [Mode]
> The display shows [Q . E PS]
► Press the key [▼] until the parameter [Q . S i6] is shown
► Press [Mode]
> The signal strength is indicated in the display.
If the displayed signal strength is < 5 %, perform the following checks:
Check the lens or protective screen for contamination.
Check the adjustment and focusing.
• The pyrometer must be focused on the measuring distance.
• The measuring field must be filled to 30 %.
• The pyrometer must have free view to the pouring stream.
13 Shipping, packing and disposal
Inspection after shipping
Unpack and inspect the entire shipment immediately upon receipt to make sure it is complete
and undamaged. If the container/package shows visible signs of damage, please refuse the
shipment. If this is not possible, accept the shipment on the condition that the freight carrier's de-
livery record is noted with the extent of the damage in order to file a claim. Should you discover
a concealed loss or damage, report it to the shipper or freight carrier immediately. If the period
for filing claims has expired, you will no longer be able to make any claims for compensation
of damage or loss.
Calculated signal strength
In [%]
EN