Cs1001 Graco Snug Ride Classic Connect Infant Car Seat Installation - BOB CS1401 Manual De Instrucciones

2. Align Infant Car Seat
Place Infant Car Seat "rear facing",
directly centered on top of ICSA,
aligning Groove Features of Infant
Car Seat with Front Spacers on ICSA.
3. Verify Infant Car Seat is Latched
Properly
Push Infant Car Seat straight down
onto ICSA. "Look and listen for
Plastic Hook" on Infant Car Seat to
latch under main front tube on ICSA.
4. Verify Infant Car Seat Hooks are
Engaged
Push down on forward edge of Infant
Car Seat (end where infant's feet go);
listen for Steel Loops on Infant Car
Seat to engage with ICSA.
CLICK
CS1001 GRACO SNUG RIDE CLASSIC
CONNECT INFANT CAR SEAT
INSTALLATION
Failure to properly secure
Restraint Belt and to properly
install Infant Car Seat on Infant
Car Seat Adapter may result
in accident, injury or death.
CLICK
NOTE: Pull Infant Car Seat Release
Handle slightly while pushing down
on front edge of Infant Car Seat (end
where infant's feet go), then let go
of Release Handle to engage Steel
Loops on Infant Car Seat onto Hooks
on ICSA.
5. Verify Infant Car Seat is
Securely Attached
Pull up on Infant Car Seat Carry
Handle to verify Infant Car Seat is
securely attached.
6. Secure Restraint Belt
Proceed to section titled "Securing
Restraint Belt" (pg. 13).
INFANT CAR SEAT
INSTALLATION
Proceed to the section for your
brand of Infant Car Seat.
CLICK
12
P636900A