Securing Restraint Belt - BOB CS1401 Manual De Instrucciones

1. Prepare Stroller
Set parking brake, rotate canopy
towards handlebar, place Restraint Belt
ends to the sides of stroller seat (see
stroller owner's manual if necessary).
2. Align Infant Car Seat
Place Infant Car Seat "rear facing",
directly centered on top of ICSA,
aligning Groove Features of Infant
Car Seat with Front Spacers on ICSA.
3. Verify Infant Car Seat is Latched
Properly
Push Infant Car Seat straight down
onto ICSA. "Look and listen for
Plastic Hook" on Infant Car Seat to
latch under main front tube on ICSA.
4. Verify Infant Car Seat Hooks are
Engaged
Push down on forward edge of Infant
Car Seat (end where infant's feet go);
listen for Steel Loops on Infant Car
Seat to engage over hooks on ICSA.
NOTE: Pull Infant Car Seat Release
Handle slightly while pushing down on
front edge of Infant Car Seat (end where
infant' s feet go), then let go of Release
Handle to engage Steel Loops on Infant
Car Seat onto Hooks on ICSA.
5. Verify Infant Car Seat is Securely
Attached
Pull up on Infant Car Seat Carry Handle to
verify Infant Car Seat is securely attached.
6. Secure Restraint Belt
Proceed to section titled "Securing
Restraint Belt" (Below).
CLICK
CLICK

SECURING RESTRAINT BELT

Failure to properly secure
Restraint Belt may result in
accident, injury or death. Be
sure Restraint Belt tension
is not constricting child as it
may cause serious injury or
death.
13
P636900A