Publicidad
Idiomas disponibles
Idiomas disponibles
Note the unpainted section of the tubes. This will be used
as a guide to assemble the tubes together.
16
Insert the top long tube into the top tube of the 3-tube
assembly.
Note: If tube joints are tight, Soapy Water
can be used.
18
Repeat for the other side. Tubes will need to be slide in
evenly to prevent binding.
Note: Make sure straps are already installed on
center tube before completing assembly.
20
PG 5/6
Slide the center tube into the center tube of the 3-tube
assembly. Straps will be pre-assembled to center tube.
Insert tube until edge of unpainted section meets mating
tube.
17
Insert the bottom long tube into the bottom tube of the
3-tube assembly.
19
Insert/attach the Bed Extender to the mounted Pivot
Brackets, adjusting width if neccessry. Leave the Bed
Extender attached to the brackets for the following steps,
while attaching the two bumper uprights.
21
Publicidad
