Suzuki 990DO-23HLT-CRB Manual Del Usuario página 6

NOTE: Indicates special information to make maintenance easier or
NOTE: If you do not feel technical qualified to install this product on your own,
please consult with your nearest SUZUKI dealer.
Preparation 1. Park the motorcycle on a firm, flat surface where it will not fall over.
for 2. Stop the engine and remove the ignition key, wait until the engine has cooled
down
installation
3. Read these instructions carefully before installation and check that all items
are correctly packed in the kit.
4. Remove riders seat and dismount the under seat covers left and right.
5. Remove the screws of the original fuel tank cover left and right and keep it.
6. Pull the Covers slightly that the hooks and loops releases.
7. Take off the fuel tank cover by pulling it in direction of the motorcycle tail.
8. Remove the aluminum bushing and the three rubber bushings from the
original cover and keep them.
Installation: 1. Install the three rubber bushings and the aluminum bushing in the similar
position at the carbon covers
2. Clean area a, b and c with proper cleaner at the left and right side.
Glue the cellular rubbers "2" at position c to the motorcycle frame, and the
3.
Velcro "3" at position b to the fuel tank at left and right side.
Pull of the protection foil from the Cellular Rubbers "2" and stick it to the tube
4.
of the motorcycle frame at left and right side.
_______________________________________________ SUZUKI GENUINE ACCESSORIES
®
Indicates potential hazard that could result in vehicle damage.
Instructions clearer.
.