Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
English
Fig. I
1
State of charge indicator
This appliance includes a state of charge indicator which
consists of three white LED lights that indicate the level
of charge remaining in the battery. This feature is only
activated when the vacuum is powered on or during a
charge cycle.
The state of charge indicator is an indication of approximate
levels of charge remaining in the battery pack according to
the following indicators:
The LED battery indicator displays the remaining charge
and warns you when the battery is low. The final LED will
flash continuously when there is only 1 minute of runtime
remaining. All LEDs will flash when the unit is discharged.
nOTE: The state of charge indicator is only an indication
of the charge left on the battery. It does not indicate tool
functionality and is subject to variation based on product
components, temperature and end-user application.
Using an Accessory tool (Fig. J)
Your vacuum may come with some of the following tools.
Small crevice tool.
-
-
6 Brush tool.
-
Pet hair tool.
•
The accessory tool
13
directly to the extension tube
inlet
5
as shown in Fig. J.
•
Align the top of the accessory tool
with the vacuum inlet
into place so it locks into position as shown in Fig. J.
Fig. J
13
Cleaning and emptying the vacuum
WARNING:
Never use the vac without its filter.
nOTE: The filter is re-usable, do not confuse it with a
disposable dust bag, and do not throw it away when the
8
4
2
,
,
can be fitted either
14
15
7
or to the vacuum
13
,
14
,
5
or extension tube
7
and push
Projectile/Respiratory Hazard:
product is emptied. We recommend that you replace the
filter every 6–9 months depending on frequency of use.
There are two methods of cleaning the canister, a quick
empty method and a thorough clean method.
To empty the dust canister (Fig. K, L)
•
Lift and remove the lift away dust canister
chassis
23
•
Place the dust canister over a trash bin and press the
dust canister lid release button
canister as shown in Figure L.
•
Close the dust canister lid
into position.
•
Install the lift away dust canister
chassis
23
Fig. K
25
Fig. L
25
15
Removing pre-filter (Fig. K, L, M)
•
Lift and remove the lift away dust canister
chassis
23
•
Place the dust canister over a trash bin and press the
dust canister lid release button
5
canister as shown in Figure L.
7
•
Use your index finger and thumb to pinch the pre-filter
pull the pre-filter
shown in Fig. M.
nOTE: The filter housing fits snuggly in the dust canister
and may be difficult to remove at first.
•
Empty the dust canister into a trash bin.
nOTE: It is recommended that you agitate the filter
when the pre-filter
section for instructions.
•
Install the pre-filter
ensuring the dust canister tab
filter slot
as shown in Figure K.
24
25
, until it clicks firmly
10
.
10
as shown in Figure K.
24
26
from the dust canister
26
is removed. See Filter Agitator
26
into the dust canister
27
28
as shown in Fig. M.
10
from the
to empty the dust
back onto the
10
23
24
10
from the
to empty the dust
26
,
10
as
10
aligns with the pre-
Publicidad
Tabla de contenido
