Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
•
Install the dust canister onto the vacuum, until it clicks
firmly into position.
Fig. M
26
10
Filter Agitator (Fig. K, L, N)
•
Lift and remove the lift away dust canister
chassis
23
as shown in Figure K.
•
Place the dust canister over a trash bin and press the
dust canister lid release button
canister as shown in Figure L.
•
Use your index finger and thumb to pinch the pre-filter
26
, pull the pre-filter
shown in Fig. M.
nOTE: The filter housing fits snuggly in the dust canister
and may be difficult to remove at first.
•
Rotate the filter agitator wheel
over a trash bin to remove excessive dust from the filter.
•
Empty the dust canister into a trash bin.
•
Install the pre-filter
26
ensuring the dust canister tab
filter slot
28
as shown in Fig. M.
•
Install the dust canister onto the vacuum, until it clicks
firmly into position.
iMPORTAnT: Maximum dust collection will only be
obtained with clean filters and an empty dust canister.
If dust begins to fall back out of the product after it is
switched off, this indicates that the dust canister is full and
requires emptying.
Fig. N
23
28
10
from the
24
to empty the dust
26
from the dust canister
9
five to ten revolutions
into the dust canister
10
27
aligns with the pre-
9
Removing filter (Fig. K, L, O)
•
Lift and remove the lift away dust canister
chassis
23
•
Place the dust canister over a trash bin and press the
dust canister lid release button
canister as shown in Figure L.
•
Grasp the agitator wheel housing
to remove.
•
Remove the filter
housing
•
Shake off or lightly brush any loose dust from the filter.
27
•
Install the the filter
agitator wheel housing
•
Install the agitator wheel housing
canister, until it clicks firmly into position.
Fig. O
29
30
10
as
10
Cleaning the filters
•
Once the filter and pre-filter are removed from the dust
canister shake off or lightly brush any loose dust from
the pre-filter
•
Rinse out the dust canister
•
Wash the filters with warm soapy water.
•
Ensure the filters are completely dry before refitting.
•
Follow instructions in the Removing pre-filter and
Removing filter sections for assembly instructions.
iMPORTAnT: Maximum dust collection will only be
•
obtained with clean filters and an empty dust canister.
If dust begins to fall back out of the product after it is
switched off, this indicates that the dust canister is full
and requires emptying.
•
Wash the filters regularly using warm, soapy water and
ensure that it is completely dry before using again. The
cleaner the filter is, the better the product will perform.
•
It is very important that the filters are completely dry
and correctly in position before use.
as shown in Figure K.
24
29
30
, from the agitator wheel
29
as shown in Fig. O.
30
, into the
29
.
29
26
and filter
30
.
10
with warm soapy water.
English
10
from the
to empty the dust
and pull up
onto the dust
9
Publicidad
Tabla de contenido
