Assembly - Ryobi RY40807 Manual Del Operador

DRIVE SPEED CONTROL LEVER
Allows user to set the direction and maximum speed settings
for the self-propelled feature.
FOUR ACTIVE BATTERY PORTS
This product has four active battery ports, two ports on the
left (PAIR A) and two ports on the right (PAIR B). To use the
blower there must be at least two 40V batteries on either
the left side (PAIR A) or the right side (PAIR B). For optimal
performance, installing four 40V battery packs of 4Ah or
greater is recommended.
HEATED HANDLE GRIPS
The heated handle grips can keep your hands warm during
cold weather conditions.
UNPACKING
This product requires assembly.
 Carefully remove the product and any accessories from
the box. Make sure that all items listed in the Packing
List are included.
WARNING:
Do not use this product if any parts on the Packing List
are already assembled to your product when you unpack
it. Parts on this list are not assembled to the product by
the manufacturer and require customer installation. Use
of a product that may have been improperly assembled
could result in serious personal injury.
 Inspect the product carefully to make sure no breakage
or damage occurred during shipping.
 Do not discard the packing material until you have
carefully inspected and satisfactorily operated the
product.
 If any parts are damaged or missing, please call
1-800-525-2579 for assistance.
PACKING LIST
Snow Blower
Upper Handle Assembly
Chute Deflector
Support Pole
Handle Knobs w/Bolts (4)
Bolts (M6) [4]
Torx Wrench
Torx Screws (T25) [2]
Operator's Manual
FEATURES
LED HEADLIGHTS
The LED headlights located on the control panel and auger
housing illuminate your path in low light conditions.
SELF-PROPEL PADDLE
Squeezing the self-propel paddle while the motor is running
activates the self-propelled feature.
START BUTTON AND AUGER PADDLE
The start button and auger paddle are located on the control
panel. Depress the start button then engage the auger paddle
to start the motor and auger. Release the auger paddle to
stop the motor.
NOTE: The motor and auger will also start if the paddle is
engaged first and the start button is pressed after.

ASSEMBLY

WARNING:
To avoid the risk of injury, do not operate without
discharge chute in place.
WARNING:
If any parts are damaged or missing, do not operate this
product until the parts are replaced. Use of this product
with damaged or missing parts could result in serious
personal injury.
WARNING:
Do not attempt to modify this product or create
accessories not recommended for use with this product.
Any such alteration or modification is misuse and could
result in a hazardous condition leading to possible serious
personal injury.
WARNING:
Do not insert battery packs until assembly is complete
and you are ready to use snow blower. Failure to comply
could result in accidental starting and possible serious
personal injury.
WARNING:
To prevent accidental starting, do not make any
adjustments or installations with the battery packs
inserted. Accidental starting of the snow blower during
assembly could result in serious personal injury.
7 — English