Important Safeguards; Main Components - Sinbo ST 2416 Manual De Instrucciones

IMPORTANT SAFEGUARDS

* This appliance has a polarized plug (one blade is wider than the other). To reduce the
risk of electric shock, this plug is intended to fit into a polarized outlet only one way. If
the plug does not fit fully into the outlet, reverse the plug. If it still does not fit, contact
a qualified electrician. Do not attempt to modify the plug in any way.
* Do not operate any appliance with a damaged cord or plug or after the appliance
malfunctions or has been damaged in any manner. Return appliance to the nearest
authorized service facility for examination, repair, or adjustment
* The use of accessory attachments not recommended by the appliance manufacturer
may cause injuries.
* Do not let cord hang over edge of table or counter, or touch hot surfaces.
* Do not place on or near a hot gas or electric burner, or in a heated oven.
* Do not use appliance for other than intended use.
* Avoid contacting moving parts.
PLEASE KEEP THESE INSTRUCTIONS
Note: This appliance is intended for household use only.
SAVE THESE INSTRUCTIONS

MAIN COMPONENTS

A. Start control
A
B. Cancel/Stop
C. Timing control
C
D
D. Crumb tray
B
OPERATION
* Place your toaster on a flat, dry, stable surface.
* Plug the toaster in, and adjust it to your required toasting time, using the Timing control
(C)
* Place bread or other food suitable for toasting into the slot, then press down the start
control /plunger (A);
* It will remain down until the bread is toasted. The logo will be displayed on the bread.
* If you wish to stop the toasting process, press the Cancel/Stop button (B). this will
automatically eject the toast, and cancel the heating elements.
* If the bread sticks in the toaster, unplug it, wait for it to cool, then remove the bread.
NEVER USE METAL UTENSILS TO REMOVE THE BREAD.
* After use, wipe away crumbs using a dry cloth.
* Always allow at least 1 minute's cooling time between cycles if toaster is being used
more than once at a time.
* If the lead connecting the toaster to the power supply is damaged, it should only be
replaced by a qualified service engineer or the toaster manufacturer.
* Always allow at least 1 minute's cooling time between cycles if toaster is being used
more than once at a time.
- 8 -