Tabla de contenido
Publicidad
12/01/20 10:10:44 32YG0620_023
1.
Start the engine according to the procedures described in page
2.
Set the throttle at the desired speed.
After starting the engine, move the throttle lever to the FAST position
for self-priming, and check pump output.
Pump output is controlled by adjusting engine speed. Moving the
throttle lever in the FAST direction will increase pump output, and
moving the throttle lever in the SLOW direction will decrease pump
output.
THROTTLE LEVER
F
F
A
A
S
S
T
T
Oil Alert System (where equipped)
The Oil Alert System is designed to prevent engine damage caused by
an insufficient amount of oil in the crankcase. Before the oil level in the
crankcase can fall below a safe limit, the Oil Alert System will auto-
matically stop the engine (the engine switch will remain in the ON
position).
If the engine stops and will not restart, check the engine oil level (see
page
12
) before troubleshooting in other areas.
S
S
L
L
O
O
W
W
7.
OPERATION
FAST
17
.
SLOW
21
Publicidad
Tabla de contenido
