Pre-Operation For Starting - Honda Power Products WB20XT Manual De Explicaciones

1. Connect the suction hose.
Use commercially available hose, hose connector, and hose bands.
The suction hose must be of reinforced, noncollapsible construction.
Suction hose length should not be longer than necessary, as pump
performance is best when the pump is not far above the water level.
Self-priming time is also proportional to hose length.
The strainer that is provided with the pump should be attached to the
end of the suction hose with a band, as shown.
CAUTION:
Always install the strainer on the end of the suction hose before
pumping. The strainer will exclude debris that can cause clogging or
impeller damage.
SUCTION PORT

4. PRE-OPERATION FOR STARTING

HOSE
CONNECTOR
HOSE CONNECTOR
HOSE BAND
SUCTION HOSE
SEALING WASHER
HOSE COUPLING
HOSE CLAMP RING
HOSE BAND
SUCTION HOSE
STRAINER
HOSE BAND
9