Taurus Tensio Precise Plus Manual De Instrucciones página 20

- Put the battery in its compartment,
respecting the polarity (Fig. 1)
- Close the cover of the battery
compartment.
- It is essential that the batteries
should always be the same kind and
the same charge. Never mix alkaline
batteries with normal one (Carbon-
Zinc) and/or rechargeable ones.
- NB: When changing the batteries,
the configuration of the appliance
will be removed, and you will need to
reset the parameters of the appliance.
Instructions for use
Before use:
- Remove the appliance's protective
film.
- Make sure that all the product's
packaging has been removed.
- Prepare the appliance according to
the function you wish to use.
Adjustment of date and time:
- Press at the same time the start/
stop button (B) and the memory
button (C).
- The figure for the month will start
to flash. Press the memory button to
select the appropriate month.
- Then press the start/stop button to
change the day, which will start to
flash. Press the memory button to
select the appropriate day.
- Then press the start/stop button to
change the hour, which will start to
flash. Press the memory button to
select the appropriate hour.
- Then press the start/stop button to
change the minute, which will start
Manual Tensio Precise Plus.indb 20
to flash. Press the memory button to
select the appropriate minute.
- Press the start/stop button again
to finalise the date and time ad-
justment. The hour set will be shown
without flashing.
- The date and time will be shown at
intervals of approximately 5 seconds.
Connecting the wristband and air tube
to the appliance:
- Completely unroll the air hose and
connect it to the air hose connection
(Fig. 2)
- To disconnect the air hose, simply
pull it outwards.
Use:
- Completely unroll the wristband and
the hose.
- Couple the hose to the hose con-
nection.
- Insert the end of the wristband
through the metal hasp leaving the
Velcro on the outer side.
- Uncover the left arm and insert the
arm into the wristband in such a way
that the hose outlet is aligned with
the centre of the arm, taking the
middle finger as a reference (Fig. 2)
- Place the arm on the table palm-
upwards.
- Place the wristband on the upper
arm, maintaining a distance of
approximately 1-2 cm between the
wristband and your elbow.
- Straighten the wristband to ensure
there is no air between it and the
arm, and adjust it using the Velcro
closing.
- Measurements must always be taken
with the arm uncovered or with the
sleeve rolled up, without exercising
12/05/11 8:43