Set Up And Operation; Control Modes - TECshow NAVIGATOR SPLIT RDM Manual De Usuario

4. INSTALLATION
Remove all packing materials from the Navigator
Split RDM. Check if all foam and plastic padding is
removed. Connect all cables.
• Do not supply power before the whole sys-
tem is set up and connected properly.
• Always disconnect from electric mains pow-
er supply before cleaning or servicing

5. SET UP AND OPERATION

Follow the directions below, as they pertain to your
preferred operation mode. Before plugging the
unit in, always make sure that the power supply
matches the product specification voltage. Do not
attempt to operate a 120V specification product on
230V power, or vice-versa. Connect the device to
the main power supply.

Control Modes

Multiple RDM Splitters (DMX control)
1) Fasten the distributor to a 19-inch rack.
2) Use a 3-pin/5-pin XLR cable to connect the Navi-
gator Split RDM and other devices.
P. 6
Tecshow Navigator Split RDM | English version
3) Connect the first unit's "in" socket to a light
controller.
4) Link the units as shown in figure. Connect the
first unit's DMX "link" socket with the second unit's
"in" socket, using a DMX signal cable. Repeat this
process to link the second, third, and fourth units.
5) Connect light fixtures to the unit's DMX "out-
"sockets.
6) Supply electric power: Plug the unit's mains pow-
er cord into proper electric power supply sockets,
starting with the first unit. Do not supply power
before the whole system is set up and connected
properly.