TECshow NAVIGATOR SPLIT RDM Manual De Usuario página 9

No light or LEDs/lamp cuts out
intermittently
Design and product specifications are subject to change without prior notice.
Data link not terminated with 120
Ohm termination plug
Incorrect addressing ofthe fixtures ■ Check address setting
One of the fixtures is defective
and disturbs data transmission on
the link
3-pin/5-pin XLR Out on the fix-
tures does not match (pins 2 and 3
reversed)
Fixture is too hot
LEDs/lamp damaged
The power supply settings do
not match local AC voltage and
frequency
■ Insert termination plug in output
jack of the last fixture on the link
■ Bypass one fixture at a time until
normal operation is restored: un-
plug both connectors and connect
them directly together
■ Have the defective fixture ser-
viced by a qualified technician
■ Install a phase-reversing cable
between the fixtures or swap pin
2 and 3 in the fixture that behaves
erratically
■ Allow the fixture to cooldown
■ Clean the fan
■ Make sure air vents in control
panel and the front lens are not
blocked
■ Turn up the air conditioning
■ Disconnect the fixture and re-
turn it to your dealer
■ Disconnect fixture. Check set-
tings and correct if necessary
English version | Tecshow Navigator Split RDM
P. 9