Publicidad
Idiomas disponibles
Idiomas disponibles
Enlaces rápidos
2003-08 Fascia
Hitch Shown In Proper Position
Equipment Required:
Fastener Kit: 51171F
Wrenches: 17mm, 19mm
For vehicles with appearance
panel:
Remove appearance panel which
covers the trunk pan.
(2)10mm
Remove the plastic rivets that
fasten the fascia tabs to the
vehicle. Note: Remove the center
of the rivet with a screwdriver.
Rivets to be reinstalled.
Return appearance panel and
fasteners to vehicle owner.
1 1 1 1
Qty. (4)
Hex Bolt, M12 X 1.25 X 35 CL8.8
2 2 2 2
Qty. (4)
Conical washer ½"
If present, remove the tie down brackets from vehicle frame rail. Return bolts and tie down bracket to owner.
1.
Raise hitch into position and install fasteners as shown above.
2.
Tighten all fasteners with torque wrench to 68 Lb.-Ft. (92 N*M)
Tighten all M12 CL8.8 fasteners with torque wrench to 68 Lb.-Ft. (92 N*M)
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
z
2009, 2012, 2014 Cequent Performance Products
Printed in Mexico
Installation Instructions
Toyota Corolla
2009 Fascia
Drawbar Kit:
3593
Drawbar must be used in
the RISE position only.
Note: Fasteners typical
both sides
Frame rails
Existing weldnuts
Do Not Exceed Lower of Towing Vehicle
2000 LB (908 Kg) Max Gross Trailer Weight
200 LB (90.8 Kg) Max Tongue Weight
3 3 3 3
Qty. (4)
Flat washer ½"
Sheet 1 of 3
51171N
Part Numbers:
51171
97171
Manufacturer's Rating or
Accessory Rating
Wiring Access Location: PC3, 4
3
Note: 2014
Use flat washers (items 3)
as needed as spacer if
trunk reinforce interferes
with hitch installation.
2
1
1-14-14
Rev. C
Form F206 Rev A 5605
A
Publicidad
Manuales relacionados para Reese 51171
Resumen de contenidos para Reese 51171
- Página 1 Installation Instructions Part Numbers: 2003-08 Fascia 51171 Toyota Corolla 97171 2009 Fascia Drawbar Kit: Do Not Exceed Lower of Towing Vehicle 3593 Manufacturer’s Rating or 2000 LB (908 Kg) Max Gross Trailer Weight Drawbar must be used in the RISE position only.
- Página 2 Numéros de pièces : 2003-08 Carénage 51171 Toyota Corolla 97171 2009 Carénage Ensemble de barre de remorquage : Ne pas excéder les spécifications du fabricant de véhicules de remorquage, ou 3593 La barre de remorquage doit 2000 lb (908 kg) Poids brut max. de la remorque être utilisée dans la position...
- Página 3 Instrucciones de instalación Números de partes: 2003-08 Placa protectora 51171 Toyota Corolla 97171 2009 Placa protectora No supere el valor inferior entre la calificación del fabricante del vehículo del remolque o Kit de barra de tracción: 3593 2000 LB (908 Kg) Peso bruto máximo del remolque La barra de tracción se debe...