Reese 51152 Instrucciones De Instalación

Frame Rail
Hitch Shown In Proper Position
Equipment Required:
Fastener Kit: 51152F
Wrenches: 14mm, 18mm
Drill Bits: None
Tie Down Bracket
And Bolts
Fasteners Typical
Both Sides
1
Qty. (4) Hex Bolt M12 x 1.25 x 30mm CL8.8
1. Remove tie down bracket and bolts on driver's side and return to vehicle owner.
2. Raise hitch into position, and using existing weldnuts, install four (4) M12 bolts as shown above.
Tighten all M12 x 1.25 CL8.8 fasteners with torque wrench to 76 Lb.-Ft. (103 N*M)
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to prevent
entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working beneath a
vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5 and
SAE J684.
z
2009 Cequent Performance Products
Installation Instructions
Suzuki Grand Vitara
Suzuki Vitara (Includes XL-7)
Chevrolet Tracker (2 & 4 Dr.)
Fascia
Existing Weldnuts
21
2
Sheet 1 of 3
Do Not Exceed Lower of Towing Vehicle
Manufacturer's Rating or
Hitch type
Trailer WT (LB)
Weight Distributing
Weight Carrying
3500 (1589 Kg.)
Ball Mount
Wiring Access Location: SUV3
Frame Rail
Qty. (4) Conical Toothed Washer ½"
51152N
Part Numbers:
51152
Max Gross Max Tongue
WT (LB)
Do Not Use With Spring Bars
350 (159 Kg.)
8-17-09 Rev. A
Form: F205 Rev A 5-6-05