Important Safety Instructions - ACM Blidoor Multibox Manual De Instrucciones

CONNECTING THE RELEASE:
Insert the release cable into its slot (Fig. 4), making certain the cable also enters the hole in the coil.
To facilitate this operation, align the hole on the coil with its corresponding hole on the switch box.
Secure the release cable by tightening the M5 pin on the coil, using the hexagonal spanner supplied
in the kit. Make sure that it has been tightened firmly and cut off any excess cable (Fig.5).
fig. 4
SUPPORT ALARM ACTIVATOR:
the multibox is ready for installing the alarm activator through the use of a special support (which is
not included in the kit)

IMPORTANT SAFETY INSTRUCTIONS:

• Only use when necessary and do not allow children to play with the control device.
• Keep an eye on the automatic device when in operation, keeping people away from the
area until the operation has been completed.
• Make sure that the automatic device and relative safety systems are in good working order.
• Contact the installer immediately if you are unable to operate the device or observe any
anomalies.
MAINTENANCE:
The device does not require maintenance.
6
fig. 5
fig. 6