Cleaning And Maintenance; Troubleshooting; Error Messages - Princess HEALTHY TURBO BLENDER Manual De Usuario

CLEANING AND MAINTENANCE

• Always disconnect the blender from the mains power supply before
cleaning.
• Do not clean the main body in a dishwasher. Do not immerse the main
body in water or any liquids.
• Clean the surface of the base unit and the outer of the jar with the
supplied sponge or with a soft, damp cloth. Rinse the lid in warm,
soapy water.
• To clean the inside of the jar, rinse and remove any remaining
ingredients.
Caution: the blades inside the jar are not removable and are very
sharp; extreme caution should be taken when cleaning the inside of
the jar.
• Fill the jar half full with warm water and add a couple drops of liquid dish
washing detergent to the jar.
• Install the lid and select the grinding program and let the blender clean
itself. If the jar is not completely clean you can repeat this method.
• After cleaning turn off the blender and rinse and drain the jar.
• Make sure the blender jar and the blades are completely dry before you
store it.
TROUBLE SHOOTING
Problems
The unit is not working and
beeping
The unit has stopped in the mid-
program (during the operation)
The unit turned off automatically

ERROR MESSAGES

Message Causes
E1 Some food got stuck inside
jar. Product is in protection
situation.
E4 Water goes inside PCB
board
E5 Water goes inside PCB
board
Cause and solution
1. The jar is not properly fitted onto the base,
press on the jar.
2. The lid is not fitted properly make sure the
marks on the lid and the jar will match.
1. The lid is loose, make sure the marks on the
lid and the jar will match.
2. The jar is gone loose from the base. Press
on the jar and the process will resume.
After one minute of no interaction the Healthy
Turbo Blender will turn off automatically.
Solutions
Take out plug and get out
the food which stuck
Take out the plug. Please
send back to Customer
Service.
Take out the plug. Please
send back to Customer
Service.
EN
9