Raider RD-HG20 Manual Del Usuario página 7

1. General instructions for safe operation.
Read all instructions carefully. Failure of the nature following instructions can cause electric
shock, fire and / or severe injuries. Keep these instructions in a safe place.
For your safety. The tool can only be used safely after the operating instructions have been
read and fully complied with.
1.1. Do not use the tool if damp or if the surroundings are damp.
1.2. Always check the tool, power cord and plug before use. In the event of damage, repair
work should only be carried out by a specialist.
1.3. Be careful when using the appliance in places where are combus¬tible materials. Do not
apply to the same place for a long time.
1.4. Always ensure the workplace is well ventilated. Never use the tool as hair drier.
2. Safety instructions when using electricity
2.1. Only connect the power lug when the tool is OFF. Disconnect the power plug after use.
Always disconnect the power plug before performing any work on the tool.
2.2. Do not carry the tool by the power cord.
2.3. Always keep the extension cable well away from the workplace. .
2.4. Before start-up make sure that the correct voltage is used. The voltage specified on the
nameplate must conform to the supply voltage. Tools rated for 230V can also be operated on
220V power supply.
2.5. The power cord and plug must be in perfect condition.
3. Safety instructions for exploitation.
3.1. Danger of burns!
3.2. Do not touch the hot nozzle (1).
3.3. Wear protective gloves
3.4. Place on its stand after use and allow cooling before storage. Keep the tool and
accessories out of the reach to children.
3.5. A hot nozzle (1) can cause damage. Do not leave the appliance unattended when in use.
3.6. Never direct the hot air flow at persons or animals.
3.7. Danger of fire and explosion! Afire may arise if the appliance is not used with care. Heat
may be conducted to combustible materials which are out of sight. Inflammable and poisonous
gases may be produced when working with plastics, paints (especially older types of paint),
varnishes and similar materials. Never use the tool in the proximity of highly inflammable gases
of materials. Do not use in presence of an explosive atmosphere. Do not hold the nozzle outlet
too close to the workplace. Only use original accessories. Not all the illustrated or described
accessories are included in standard delivery.
4. Intended use
The appliance is suitable for th removal of wild growth between paving slabs, on brick-
paved areas, on walling, in flowerbeds and in lawns during the growth periods, for the removak
of paintworkm for heating(e.g. of heat-shrinkaboe tubing)and for the deformation and welding
of plastics. It can also be used for separating glued joints, thawing frozen pips and lighting
barbecues. Any other usage of or modification to appliance is deemed to be improper and
carries a significant risk of accidents. The manufacturer accepts no responsibility for damage
(s) attributable to misuse. The appliance is not intended for commercial use.
5. Operation
Push the loop of the extension cable into the provided strain relief (2) in the handle (1) and
fix it to the bar provided.
Connect the appliance to a power socket (230V alternating current)using an extension cable.
Switch the appliance on by pressing the ON/OFF switch (4).
The full operating temperature is reached after approx. 1 minute.
To kill weeds, now place the cone nozzle (9) onto the plant to be treated for around 5-10
seconds depending on the type of plant.
For taller plants, first only heat the upper section of the plant briefly and then place the cone
nozzle (9) against the shrunken plant for approx. 5-10seconds.
7