Dc Charging Adapter - Wagan Tech SOLAR e POWER CUBE 1500 Manual De Usuario

make Sure all Solar e Power Cube SwiTCheS are SeT To oFF.
1. Connect the AC Charging Adapter to an AC wall socket.
2. Insert the charger's DC plug into the Solar e Power Cube's DC Outlet.
3. Turn ON the Battery Disconnect Switch.
4. Charging is complete when the light on the AC charger turns green.
5. After charging the battery, disconnect the adapter from the AC wall socket first, then
from the DC Outlet.
6. Turn OFF the Battery Disconnect Switch if the Solar e Power Cube is not in use.
7. Store the AC Charging Adapter in the Storage Hatch.

DC Charging Adapter

The DC Charging Adapter is a cord with a fused DC accessory plug at both ends. Both plugs
are fused at 15 amps to prevent damage if there is an inadvertent short. Refer to the mainte-
nance section to replace a fuse if necessary.
Plug DC Charging Adapter into vehicle DC accessory socket
To charge the Solar e Power Cube using the DC Charging Adapter:
only uSe The dC Charging adaPTer SuPPlied wiTh ThiS uniT. do noT ConTinuouSly Charge For more Than
16 hourS uSing The dC To dC meThod.
1. Note that the engine must be running while charging the Solar e Power Cube to avoid
discharging the vehicle's battery.
2. Make sure all Solar e Power Cube switches are set to OFF.
3. Plug the DC Charging Adapter into the Solar e Power Cube's DC Outlet.
4. Plug the other end of the DC Charging Adapter into the vehicle's accessory socket
(cigarette lighter socket).
Wagan Tech and wagan.com are trademarks used by Wagan Corporation
User's Manual—Read before using this equipment
© 2013 Wagan Corporation. All Rights Reserved
13