Solar e Power
™
COnTROl PAnEl
The Control Panel contains a Digital LED Voltmeter for reading battery status, a Battery Status
Push-Button to turn on the meter, Inverter ON/OFF switch, two AC Outlets, two USB and two
12 volt Accessory Outlets. Two LEDs indicate the operating condition of the Inverter. The green
Power LED, when lit, indicates normal operation and that AC is present at the outlets. The red
Fault LED indicates the Inverter is shut down because of any of the following reasons: over volt-
age, under voltage, over temperature or overload. Refer to the Troubleshooting section to resolve
the problem. Two terminals allow additional solar panels to be connected to the internal Solar
Charge Controller. The Battery Disconnect Switch is located to the left of the control panel. A
Storage Hatch contains the DC and AC Charging Adapters.
Digital LED
Voltmeter
Voltmeter
Push-button
2 AC Outlets
(Inverter)
8
Cube 1500 by Wagan Tech
ITEM# 2546
VOLTMETER
DISPLAY
1500W, 220V AC
12V DC Accessory Outlets
Control Panel
www.wagan.com
®
Inverter
Power Switch
INVERTER
FAULT
POWER
2.1A USB
1.0A USB
+
SOLAR
TERMINALS
−
Red Inverter
Fault LED
Green Inverter
Power LED
USB Outlets
Solar Panel
Terminals
Positive (+)
Negative (−)