Cleaning The Cooktop; Control Panel And Knobs; Cooktop Surface - GE JGB860DEJWW Manual Del Propietário

Cleaning the Cooktop

Control Panel and Knobs

a damp cloth. For cleaning, use mild soap and water or
Do not use abrasive cleansers, strong liquid cleansers,
plastic scouring pads or oven cleaners on the control
Stainless Steel Surfaces (on some models)
Do not use a steel wool pad; it will scratch the surface.
To clean the stainless steel surface, use warm sudsy
water or a stainless steel cleaner or polish. Always wipe
the surface in the direction of the grain. Follow the cleaner
instructions for cleaning the stainless steel surface.
Cleaners with oxalic acid such as Bar Keepers Friend
and rub in the direction of the brush lines with a damp,
soft sponge.
To inquire about purchasing cleaning products
including stainless steel appliance cleaner or polish,
beginning of this manual.

Cooktop Surface

Do not use oven cleaners, abrasive cleansers, strong
liquid cleansers, steel wool, plastic scouring pads, or
cleaning powders on the cooktop surface. Clean with a
room temperature and not in direct sunlight.
49-85223-2
For easier cleaning, the control knobs may be removed
by pulling them directly outwards once the knobs are in
the OFF position. Do not pull knobs up or down or hang
This can damage the gas valve shaft.
these knobs must be placed in the same location after
cleaning. See the Surface Burner section for a detailed
view of these knobs. The knobs can be washed by hand
with soap and water or in a dishwasher.
To replace knobs after cleaning, align the hole on
the knob backside with the gas valve shaft and push
inward until the knob is securely fastened. All knobs are
interchangeable
Surface burner knob
basting liquids containing acids may cause discoloration
and should be wiped up as soon as hot surfaces cool,
then clean and rinse.
If your model has a stainless steel cooktop surface,
refer to the Stainless Steel Surface cleaning instructions
23