GE JGB860DEJWW Manual Del Propietário página 31

Troubleshooting tips ... Before you call for service
Problem
Oven light does not
during clean cycle
Oven not clean after a
clean cycle
Strong "burning" or
"oily" odor emitting
from the vent
during broiling
or LOCKED light is on
"LOCK DOOR" flashes
in the display
"F— and a number
or letter" flash in the
display
flashes
Lock Controls or
Control Lockout feature
is activated
Burners do not light
49-85223-2
Possible Cause
Light bulb is loose or defective.
The temperature is too high to set
a self-clean operation.
Oven controls improperly set.
Oven controls improperly set.
Food too close to burner element.
The oven door is locked because
the temperature inside the oven
temperature.
The self-clean cycle has been
selected but the door is not closed.
You have a function error code.
Plug on range is not completely
inserted in the electrical outlet.
Gas supply not connected or
turned on.
or the circuit breaker tripped.
Burner parts not replaced correctly.
the round lighter port on the oval
Food residue on electrode
What To Do
Tighten or replace bulb. See the Maintenance section for
instructions on how to replace the bulb.
Allow the oven to cool and reset the controls.
See the Cleaning the Oven section.
pad. Open the windows to rid the
See the Cleaning the Oven section.
Clean up heavy spillovers before starting the clean cycle.
a longer period of time.
To speed the process, set a self-clean cycle for a
minimum of 3 hours. See the Cleaning the Oven section.
This is temporary.
Lower the rack position of the food.
pad. Allow the oven to cool below
the locking temperature.
Close the oven door.
pad. Allow the oven to cool for one
seconds and then reconnect power. If the function error code
repeats again, call for service.
it by pressing the
resetting any cooking function.
If LOC ON appears in the display, the range control is
locked. Turn this feature off to use the range. See the
Lock Control feature in the Oven Controls section.
Make sure electrical plug is plugged into a live, properly
grounded outlet.
See the Installation Instructions that came with your
range.
See the Care and Cleaning of the range section.
electrode area for burned-on food or grease. See the
Care and Cleaning of the range section.
Lightly polish flat tip of electrode with nail file or
sandpaper until shiny.
LOCKED light goes off.
pad, setting the clock and