Important Safety Instructions - Anker 333 Manual Del Usuario

EN
LED Indicators Status
Solid for 3 seconds,
Connected to power
then turns off
Solid blue Charging your devices or fully charged
• • Detected metal objects
• • Overvoltage or undervoltage protection
Flashing blue
• • Incompatible AC adapter connected, indicating
that you need to switch to a Quick Charge
2.0/3.0 or Power Delivery adapter
• This wireless charger is not compatible with non-MagSafe phone
•
cases, such as Otterbox Defender cases.
T
• • Connect the wireless charger to a Quick Charge 2.0/3.0 or Power
Delivery wall adapter. Do not connect to a 5V/1A wall charger or
a USB port on a computer as it may affect the wireless charging
function.
• • Do not place any foreign objects between your device and the
wireless charger's surface, including metal pads on a car mount,
magnetic cards, door keys, coins, NFC cards or other metal
objects, as they could potentially demagnetize the wireless
charger, affect the charging speed, or cause overheating.
• • Wireless charging products make charging more convenient than
wired chargers, but confined by current wireless technology, their
charging speed is slower than that of wired chargers.
• • High temperatures will reduce charging speed and restrict power.
It is recommended that you charge your device in environments
with temperatures below 40°C / 104°F.
01

Important Safety Instructions

Please refer to the electrical and safety information on the
bottom before installing or operating the product.
• • Avoid dropping.
• • Do not disassemble.
• • Do not expose to liquids.
• • This product is suitable for moderate climates only.
• • The maximum ambient temperature during use of this product must not
exceed 40°C.
• • Open flame sources, such as candles, must not be placed on this product.
• • Only use a dry cloth or brush to clean this product.
FCC Statement
This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Warning: Changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate the
equipment.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures: (1) Reorient or relocate the receiving antenna. (2) Increase the
separation between the equipment and receiver. (3) Connect the equipment
into an outlet on a circuit different from that to which the receiver is
connected. (4) Consult the dealer or an experienced radio / TV technician
for help.
Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated
with a minimum distance of 20 cm between the radiator & your body.
02