After-Sales Service - Whirlpool WTE25112 Instrucciones Para El Uso

AFTER-SALES SERVICE

Before contacting After-Sales Service:
1. See if you can solve the problem yourself with
the help of the "Troubleshooting guide".
2. Switch the appliance on again to see if the
problem persists.
If it does, switch off and wait for about an hour
before switching on.
3. If the problem persists after this course of
action, contact After-sales Service.
Specify:
• the nature of the problem,
• the model,
• the Service number (the number after the word
SERVICE on the rating plate on the inside of the
appliance),
INSTALLATION
• Install the appliance away from heat sources.
• Install the appliance in a dry, well-ventilated
place.
• Do not obstruct the top and bottom vent
zones.
• Clean the inside (see chapter "How to clean the
refrigerator compartment").
• Fit the accessories supplied.
• Overall dimensions with door open 110 cm
• Maximum width with door open 105 cm
Electrical connection
• Electrical connections must be made in
accordance with local regulations.
• Voltage and power consumption are indicated
on the rating plate (at the side of the crispers).
Freestanding appliances (not built-in)
• Fit the spacers (if supplied) on the rear of the
condenser positioned at the back of the
appliance (see figure).
• To optimize appliance efficiency, leave a 5 cm
gap above the appliance and make sure that
adjacent kitchen units are sufficiently distanced
to allow air circulation.
• Ensure that the appliance is level, using the
front adjustment feet if necessary.
• your full address,
• your telephone number and area code.
Note: The direction of door opening can be
changed. If this operation is performed by
After-sales Service it is not covered by the
warranty.
• Regulations require that the appliance is
earthed. The Manufacturer declines all
liabilities for injury to persons or animals
or damage to property resulting from
failure to observe these regulations.
• If the plug and socket are not of the same type,
have the socket replaced by a qualified
electrician.
• Do not use extension leads or adapters.
Disconnecting the appliance
• It must be possible to disconnect the appliance
by unplugging it or by means of a two-pole
switch fitted upline of the socket.
23