Publicidad
Idiomas disponibles
Idiomas disponibles
12. Position the lower shroud (2) over the tilt lever and
onto the column (5).
13. Install the screw attaching the lower shroud (2) to the
column (5).
14. Install the upper shroud (1) over the lower shroud (2),
clipping the shrouds to one another.
15. Install the two screws (4) attaching the upper shroud
(1) to the lower shroud (2).
16. Depress the three mounting clips (2) to disengage the
TIPM (1) from its mounting bracket and lift/tilt the TIPM
(1) up for access to the connectors on the bottom.
17. Release the lock and disconnect the C11 connector.
CAUTION: Do not remove the Terminal Position As
surance (TPA) lock. only lift enough to release.
18. Using a small pick (1) or equivalent, release the TPA
lock (2) on the face of the C11 connector (3).
Dec 09, 2010
3
K6859966 Rev. 1
Publicidad
