Publicidad
Idiomas disponibles
Idiomas disponibles
18. Secure the new BCM harness along the existing
wire harness with cable ties.
NOTE: Cable ties should be spaced no farther than
150mm apart on the inside of the vehicle.
19. From inside the engine compartment, remove
one (1) 10mm bolt and two (2) 10mm nuts at the
fuse box. Carefully lift the fuse box up out of the way.
20. Route the new harness along the existing harness
under the fuse box and up towards the battery.
Secure with cable ties.
NOTE: Cable ties should be spaced no farther than
100mm apart on the outside of the vehicle.
7/24/12
C
7
C
K6861310
Publicidad
