EAS ELECTRIC EMR145W Manual De Instrucciones página 19

CONTENTS:
Section 1. lnstallation
Section 2. Safety Advice
Section 3. Operating the Appliance
Section 4. Maintenance
Section 1. lnstallation
• IMPORTANT! This appliance must be left to stand in an upright position for
at least 4 hours before being switched on for the first time.
• This appliance has been designed for Domestic Use Only.
• Remove all packaging and securing tape from the appliance.
• Wash the interior of the appliance with luke warm water containing a small
amount of bicarbonate soda (5ml to 0.5 litres of water).
• Position the appliance in a dry atmosphere and out of direct sunlight .
• Do not position next to a cooker or other sources of heat, i.e. radiator.
• This appliance should not be sited in a cold atmosphere, i.e garage or
shed. Doing so may cause the freezer unit to underfreeze.
• lf positioned next to another fridge or freezer, leave a minimum gap of 2cm
between the appliances in order to avoid condensation.
• A clearance of 50mm should be left above the appliance. lf this cannot be
achieved you should ensure a clearance of 25mm is maintained on each
side of the appliance.
• Fit the plastic wall spacers to the condenser on the rear of the appliance,
this will ensure an air gap between the appliance and the wall.
• Do not place or store heavy items on the top of this appliance .
• Ensure that the appliance is positioned on a firm flat floor.
• This appliance must be level. Adjust the level by screwing the adjustable
feet up or down (use your fingers or a suitable spanner).
• Ensure that the appliance is upright and both feet are in firm contact with
the floor so that the cabinet is stable.
• Connect the plug to an adjacent 13amp socket out let and ensure that the
appliance is not standing on the supply cable.
3 V.1