Section 3. Operating the appliance
3.1. Switching on the Appliance
Allow the appliance to stand upright for a mínimum of 4 hours befare you
switch it on.
Plug
in
the
supply. Set the thermostat control to the required setting as detailed in the
Temperature Control section (3.2).
Leave the appliance for approximately 4 hours for the correct temperature to
be reached.
3.2. Temperature Control
The temperature selector knob is located on the lamp unit inside the refrigerator
(see Description of the Appliance on page 2).
Setting "0": Unit Off
Setting "MIN": Unit On- Warmest Temperature
Setting "NORMAL": Normal Operation (adequate for most situations)
Setting "MAX": Coldest Temperature
There is a black arrow on the knob of thermostat, Open, close and
digital block marks is printed correspondingly.
When the knob arrow turns OFF, the compressor will stop working.
Turn the arrow to ON and the compressor will start working.
The number does not represent the specific temperature value.
At room temperature, the larger the number, the lower the
temperature in the box.
The smaller the number, the higher the temperature in the box;
Digital maximum speed for fast freezing, suitable for fast refrigeration
and fast freezing material.
Don't freeze too long. Food should be frozen after the knob back to the
original block, so as not to cause the cold food to be frozen bad.
Gear position should be adjusted according to different seasons.
When defrosting is needed, press the red button in the middle, the compressor will
stop refrigeration and defrosting will start. After reaching the setting temperature of
defrosting, the compressor will automatically reset and restart for refrigeration.
appliance
and
switch
on
5
at
the
mains
V.1