Chauvin Arnoux PA32ER Manual De Instrucciones página 12

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

Thank you for purchasing this PA32ER power supply and battery charger. This accessory is designed to be used with the
Qualistar2 C.A 8345, the Scopix IV and the C.A 6117.
For best results from your instrument:
„ read these operating instructions carefully,
„ comply with the precautions for use.
WARNING, risk of DANGER! The operator must refer to these instructions whenever this danger symbol appears.
Equipment protected by double insulation.
Indoor use.
Chauvin Arnoux has adopted an Eco-Design approach in order to design this appliance. Analysis of the complete lifecycle
has enabled us to control and optimize the effects of the product on the environment. In particular this appliance exceeds
regulation requirements with respect to recycling and reuse.
The CE marking indicates compliance with the European Low Voltage Directive (2014/35/EU), Electromagnetic
Compatibility Directive (2014/30/EU), and Restriction of Hazardous Substances Directive (RoHS, 2011/65/EU and
2015/863/EU).
The UKCA marking certifies that the product is compliant with the requirements that apply in the United Kingdom, in
particular as regards Low-Voltage Safety, Electromagnetic Compatibility, and the Restriction of Hazardous Substances.
The rubbish bin with a line through it indicates that, in the European Union, the product must undergo selective disposal
in compliance with Directive WEEE 2012/19/UE: This equipment must not be treated as household waste.
Definitions of overvoltage categories
„ Overvoltage category IV concerns equipment installed where the power supply enters a building, or nearby, between the point of
entry and the main distribution frame. This equipment can include electricity meters and primary overvoltage protection devices.
„ Overvoltage category III concerns equipment that is part of the electrical installation of a building. This equipment includes
sockets, fuse panels, and some network installation control devices.
„ Overvoltage category II concerns equipment designed to be supplied from the electrical installation of the building. It includes
both equipment connected by plugs and equipment connected permanently.
ENGLISH
12

Publicidad

Tabla de contenido
loading

Tabla de contenido