Package Contents; Description (Fig. A) - DeWalt DW540 Manual De Instrucciones

10 Secure workpiece
Use clamps or a vice to hold the workpiece. It is
safer and it frees both hands to operate the tool.
11 Do not overreach
Keep proper footing and balance at all times.
12 Avoid unintentional starting
Do not carry the plugged-in tool with a finger on
the switch. Be sure that the switch is released
when plugging in.
13 Stay alert
Watch what you are doing. Use common sense.
Do not operate the tool when you are tired.
14 Disconnect tool
Shut off power and wait for the tool to come to a
complete standstill before leaving it unattended.
Unplug the tool when not in use, before servicing
or changing accessories.
15 Remove adjusting keys and wrenches
Always check that adjusting keys and wrenches are
removed from the tool before operating the tool.
16 Use appropriate tool
The intended use is laid down in this instruction
manual. Do not force small tools or attachments
to do the job of a heavy-duty tool. The tool will
do the job better and safer at the rate for which it
was intended.
Warning! The use of any accessory or attachment
or performance of any operation with this tool, other
than those recommended in this instruction manual
may present a risk of personal injury.
17 Do not abuse cord
Never carry the tool by its cord or pull it to
disconnect from the socket. Keep the cord away
from heat, oil and sharp edges.
18 Maintain tools with care
Keep the tools in good condition and clean for better
and safer performance. Follow the instructions for
maintenance and changing accessories. Inspect the
tool cords at regular intervals and, if damaged, have
them repaired by an authorized D
agent. Inspect the extension cords periodically and
replace them if damaged. Keep all controls dry,
clean and free from oil and grease.
19 Check for damaged parts
Before using the tool, carefully check it for
damage to ensure that it will operate properly
and perform its intended function. Check for
misalignment and seizure of moving parts,
breakage of parts and any other conditions that
17
20 Have your tool repaired by an authorized

Package contents

The package contains:

Description (fig. A)

Your D
for professional hammer drilling and light chipping,
chiselling and demolition applications.
WALT repair
E
10 Rear side handle position
11 Depth adjustment rod
12 Switch handle cover
13 Lower service access cover
14 Upper service access cover
15 Gearbox access cover
16 Safety lock
may affect its operation. Have damaged guards
or other defective parts repaired or replaced as
instructed. Do not use the tool if the switch is
defective. Have the switch replaced by an
authorized D WALT repair agent.
E
D WALT repair agent
E
This Power Tool is in accordance with the
relevant safety regulations. To avoid danger,
electric appliances must only be repaired by
qualified technicians.
1 Rotary Hammer
1 Side handle
1 Depth adjustment rod
1 Tube of bit lubricant
1 Kitbox (K-models only)
1 Instruction manual
1 Exploded drawing
• Check for damage to the tool, parts or accessories
which may have occurred during transport.
• Take the time to thoroughly read and understand
this manual prior to operation.
WALT Rotary Hammer has been designed
E
1 ON/OFF-switch
2 Electronic speed and impact control dial
(DW541/DW545)
3 Power-ON indicator LED (DW541/DW545)
4 Service indicator LED (DW541/DW545)
5 Mode selector lever with safety lock (16)
6 Tool holder for SDS-max
7 Collar
8 Side handle
9 Side handle clamp wheel
E N G L I S H
®
accessories
en - 3