Ec Declaration Of Conformity; Safety Instructions - DeWalt D21520 Traducido De Las Instrucciones Originales

Denotes risk of fire.
EC-Declaration of Conformity
MACHINERY DIRECTIVE
D21520
D WALT declares that these products described
E
under "technical data" are in compliance with:
98/37/EC (until Dec. 28, 2009), 2006/42/EC (from
Dec. 29, 2009), EN 60745-1, EN 60745-2-1.
These products also comply with Directive
2004/108/EC. For more information, please contact
WALT at the following address or refer to the
D
E
back of the manual.
The undersigned is responsible for compilation of
the technical fi le and makes this declaration on
behalf of D
WALT.
E
Horst Großmann
Vice President Engineering and Product
Development
D WALT, Richard-Klinger-Straße 11
E
D-65510, Idstein, Germany
04.08.2009

Safety Instructions

WARNING: To reduce the risk of injury,
read the instruction manual.
General Power Tool Safety Warnings
WARNING: Read all safety warnings
and all instructions. Failure to follow the
warnings and instructions may result in
electric shock, fi re and/or serious injury.
Save all warnings and instructions for future
reference.
The term "power tool" in the warnings refers to your
mains operated (corded) power tool or battery
operated (cordless) power tool.
1 Work Area Safety
a Keep work area clean and well lit. Cluttered or
dark areas invite accidents.
b Do not operate power tools in explosive
atmospheres, such as in the presence of
fl ammable liquids, gases or dust. Power tools
create sparks which may ignite the dust or fumes.
c Keep children and bystanders away while
operating a power tool. Distractions can cause
you to lose control.
2 Electrical Safety
a Power tool plugs must match the outlet.
Never modify the plug in any way. Do not use
any adapter plugs with earthed (grounded)
power tools. Unmodifi ed plugs and matching
outlets will reduce risk of electric shock.
b Avoid body contact with earthed or grounded
surfaces such as pipes, radiators, ranges
and refrigerators. There is an increased risk of
electric shock if your body is earthed or
grounded.
c Do not expose power tools to rain or wet
conditions. Water entering a power tool will
increase the risk of electric shock.
d Do not abuse the cord. Never use the cord
for carrying, pulling or unplugging the power
tool. Keep cord away from heat, oil, sharp
edges or moving parts. Damaged or entangled
cords increase the risk of electric shock.
e When operating a power tool outdoors, use
an extension cord suitable for outdoor use.
Use of a cord suitable for outdoor use reduces
the risk of electric shock.
f If operating a power tool in a damp location
is unavoidable, use a residual current device
(RCD) protected supply. Use of an RCD
reduces the risk of electric shock.
3 Personal Safety
a Stay alert, watch what you are doing and use
common sense when operating a power tool.
Do not use a power tool while you are tired or
E N G L I S H
19