Controls and input connections
A wide variety of external equipment can be connected to the input sockets on the side of the television.
Whilst all the necessary adjustments and controls for the television are made using the remote control, the
buttons on the television may be used for some functions.
Switching on
If the RED LED is unlit check that the mains plug is
connected to the power supply. If the picture does not
1
appear press
on the remote control, it may take a few
moments.
To put the television into Standby press
control. To view the television press
may take a few seconds to appear.
To set up the television you will now need to use the on-
screen menus. Press the MENU button on the remote
control to see the menus.
The menu bar at the top of the screens will show six
different topics shown in symbols. As each symbol is
C
c
selected by pressing
or
remote control, its respective options will appear below.
b
To use the options, press
on the navigation ring to move
down through them and OK,
choice. Follow the on-screen instructions. The functions of
each menu are described in detail throughout the manual.
GREEN LED – On timer
BLUE LED
1
on the remote
1
again. The picture
on the navigation ring on the
C
c
or
to select the required
RED LED – Standby
GREEN LED – Power on
Using the controls and connections
To alter the volume press –
To alter the programme position press
Press MENU and
picture options.
Press MENU to finish.
When connecting sound equipment to EXT3, connect the
audio output of the equipment to the phono sockets on the
television.
To select the Input, press
as described on page 26. The television will automatically
sense the type of signal.
Please always refer to the owner's manual of the equipment
to be connected for full details.
Please note: Inserting the headphone plug will mute the
sound from all speakers.
11
Standby
HDMI3
HDMI3
INPUT
INPUT
INPUT 3
(EXT3)
2
+.
b p B
I
i
U
u
,
,
or
to control the sound and
o
until the display shows EXT3
.