Operating The Leaf Blower; Switching On And Off, Operating Mode Change - FLORABEST FLB 2500 A1 Traducción Del Manual De Instrucciones Original

GB MT

Operating the leaf blower

Danger of injury.
Wear suitable clothing and
work gloves when working with
the device. Make sure that the
device is functioning properly
before every use. Make sure that
the collection bag and the tube
are assembled correctly and
the carrying strap is adjusted
correctly for work. If a switch
should be damaged, work with
the device must not be carried
out any longer. Make sure that the
mains voltage values are compat-
ible with the label on the device.
Note noise protection laws and local
regulations. The use of the device can
be restricted or prohibited on certain
days (e.g. Sundays and holidays),
during certain times of the day (lunch
hours, at night) or in special areas
(e.g. health resorts, clinics etc. ).
After switching off the device,
the impeller wheel continues to
rotate for some time. Danger of
injury due to rotating tool.
Switching on and off, operat-
ing mode change
Before switching on device, make
sure it is not in contact with any
objects. Ensure stable positioning.
The device can only be switched
on if the entire blower / suc-
tion tube is correctly mounted.
The impeller wheel cover must
be closed and the attachment
screws must be tightened.
54
C
1. Make a loop of the end of the ex-
tension cord and fasten this to the
cable support (15). By means of
this tension relief, an unintentional
pull-out of the electrical plug con-
nection is avoided.
2. Put on the carrying strap (1) and
adjust it to the optimum length.
3. Open the quick-release fastener
(7) and move the additional grip
(6) to the desired position. Re-
close the quick-release fastener.
4. Make sure that the device is
switched off and connect the de-
vice to the mains voltage.
5. In order to select the operation
mode, turn the operation mode
selector (16) to the symbol re-
quired.
Before changing the operat-
ing mode, it is absolutely
necessary that the device be
switched off.
6. For switch-on, slide the on/off switch
(9) into position "l", the device starts
up.
To switch off, slide the on/off switch
(9) into position "0", the device switch-
es off.
7. With the airstream regulator (10)
set the optimal blowing and sucking
strength.
8. During operation, hold the device
with one hand on the casing grip and
the other on the additional grip. Grip
the handles inside of the vibration-
dampened areas fitted with vibration
dampers (see
Blowing operating mode
Suction operating mode
26 + 27).
A