ASROCK P4V88 Manual De Instrucciones página 10

2.3 Expansion Slots (PCI and AGP Slots) 2.3 Expansion Slots (PCI and AGP Slots) 2.3 Expansion Slots (PCI and AGP Slots)
2.3 Expansion Slots (PCI and AGP Slots) 2.3 Expansion Slots (PCI and AGP Slots)
There are 5 PCI slots and 1 AGP slot on P4V88/P4V88+ motherboard.
PCI slots: PCI slots are used to install expansion cards that have the 32-bit PCI
interface.
AGP slot: The AGP slot is used to install a graphics card. The ASRock AGP slot has
a special design of clasp that can securely fasten the inserted graphics
card.
Please do NOT use a 3.3V AGP card on the AGP slot of this
motherboard! It may cause permanent damage! For the voltage
information of your AGP card, please check with the AGP card
vendors.
Installing an expansion card Installing an expansion card Installing an expansion card Installing an expansion card Installing an expansion card
STEP 1: Before installing the expansion card, please make sure that the power
supply is switched off or the power cord is unplugged. Please read the
documentation of the expansion card and make necessary hardware
settings for the card before you start the installation.
STEP 2: Remove the bracket facing the slot that you intend to use. Keep the screws
for later use.
STEP 3: Align the card connector with the slot and press firmly until the card is
completely seated on the slot.
STEP 4: Fasten the card to the chassis with screws.
1 0 1 0 1 0 1 0 1 0
ASRock P4V88/P4V88+ Motherboard