LaserLiner Flexi3D-Camera Manual De Instrucciones página 8

Connection to VideoControl-Master
4
Direct connection
The Flexi3D-Camera can be connected directly to the
base unit VideoControl-Master. See image on right.
Ensure that all contact pins are positioned correctly.
Connection with control cable
Use the supplied control cable as an extension or
to work more exibly. When screwing the control
cable to the Flexi3D-Camera and the VideoControl-
Master base unit on top, ensure that the arrow on
the connector plug points toward the groove of the
respective device.
The sensitive contact pins of the connector only fit into the socket in
!
this position and can be damaged if not positioned correctly or used
too forcefully.
Instructions for use
• It is absolutely vital to ensure that the Flexi3D-Camera does not come into
contact with chemicals, current, moving or hot objects. This can damage
the device and put its user at risk of serious injury.
• The camera head is not acid-resistant or reproof.
• The Flexi3D-Camera must not be used for medical examinations / examining
people.
• The unit is not suitable for taking measurements close to dangerous voltages.
Therefore always make sure that conductive parts are at zero potential when
carrying out measurements in the vicinity of electrical systems. Safe isolation
from the power supply and precautions to prevent systems being switched on
again must be ensured by implementing suitable measures.
• Clean the push rod with a damp cloth before placing it in the case.
• The camera must not be operated when the push rod is rolled up.
08 GB
2
1