GreenWorks 4100802 Manual De Utilización página 11

PROBLEM POSSIBLE CAUSES
Battery not fully installed.
(sold separately)
The power switch is in the 0 (off)
position.
Battery requires charging .
(sold separately)
The motor's thermal overload
protection has tripped.
The motor
will not run or A fuse has blown or a circuit
start. breaker has been tripped.
The air tank pressure exceeds the
preset pressure switch limit.
The safety valve is stuck open
Electrical connections are loose.
The motor, capacitor or safety
valve is defective.
The pressure switch does not
shut off the motor when the air
compressor reaches the cut-out
The motor
pressure and the safety valve
runs
activates.
continuously
when the
power switch
is in the I (on)
The compressor's capacity is not
position.
enough.
English
SOLUTIONS
Remove and reinstall the battery
(sold separately)
Set the power switch to the I (on) position.
Remove battery and fully charge and battery
charger.(sold separately)
Turn the air compressor off, unplug the power
cord and wait until the motor has cooled
down.
Replace the fuse or reset the circuit breaker.
Verify that the fuse has the proper amperage.
Check for low voltage conditions.
Disconnect any other electrical appliances
from the circuit, or operate the compressor on
a dedicated circuit.
The motor will start automatically when the
tank pressure drops below the cut-in
pressure.
. C
lean or replace the safety valve.
technician.
technician.
Set the power switch to the 0 (off) position.
If the motor does not shut off, unplug the air
compressor. If the pressure switch is defective,
replace it.
Check the air requirements of the accessory
that is being used. If it is higher than the SCFM
(Standard Cubic Feet per Minute, page 2) and
pressure supplied by the compressor, a larger
capacity air compressor is needed. Most
accessories are rated at 25% of actual SCFM
while running continuously.
11