Charging; Charging The Speaker - Denon envaya DSB50BT El Manual Del Propietario

Contents Preparation

Charging

Envaya can be charged and operated on battery power. It can also be operated from an AC power source by connecting it to the USB to AC power
adapter (available commercially) or the USB port of a computer using the supplied USB cable.
Please make sure you charge the battery completely before listening on battery power.
0 It takes at least 2.5 hours to fully charge the battery when it is completely discharged. (if using a USB to AC power adapter with an output of 2A or higher)
0 Envaya can be used for approximately 10 hours when the battery is fully charged. (The playback time may differ depending on the ambient temperature, playback volume,
and usage conditions)
NOTE
0 Only use the supplied USB cable.
0 We recommend using a USB to AC power adapter with an output of 2A or higher.
0 The rating of adapter should be less than DC 5V, 2.4A.
0 Must be used with an approved adapter suitable for the countries where the requirement will be applied.
o Charging the speaker
A Open the cap on the rear side.
B Connect the small end of USB cable to the speaker.
C Connect the large end of the USB cable to a USB to AC power adapter
and a power source or the USB port on your computer.
NOTE
0 Remove the USB cable and firmly close the cap when charging is completed.
Connections Operation
8
Troubleshooting
.
Index
Appendix