No Sound From The Speaker; Sound Is Distorted, Noisy, Or Cuts In And Out - Denon envaya DSB50BT El Manual Del Propietario

Contents Preparation

No sound from the speaker

No sound from the speaker.

The speaker is not connected to USB to AC power adapter or the battery is not charged. Connect power and turn on the speaker. (v p. 10)
0
The volume is too low on your connected device. Turn up the volume on your device to about 90 % and then adjust the volume on the speaker.
0
(v p. 17)
There is no connected Bluetooth device. Pair and connect a Bluetooth device and try again. (v p. 11)
0
There is no connected AUX device. Connect an audio device to the AUX input using a stereo 3.5mm cable and make sure music playing music on your
0
device. (v p. 18)
The AUX input connector of Envaya is compatible with stereo mini plug cables that have 3-conductor plugs. Be sure to use a 3-conductor stereo mini
0
plug cable. (v p. 18)

Sound is distorted, noisy, or cuts in and out

Sound is distorted, noisy, or cuts in and out.

The volume is too low on your connected device. Turn up the volume on your device to about 90 % and then adjust the volume on the speaker.
0
(v p. 17)
The Bluetooth device is out of range. Bring the Bluetooth device closer to the speaker.
0
The Bluetooth connection is experiencing wireless interference. Move the speaker away from appliances such as microwave ovens and other wireless
0
devices.
The Bluetooth device is having connectivity issues. Cycle the power on the Bluetooth and reconnect to the speaker.
0
Depending on the type of USB to AC power adapter connected to Envaya, a small amount of noise may occur during charging. This is not a
0
malfunction.
Connections Operation
23
Troubleshooting Appendix
Index